Datenblatt-Suchmaschine für elektronische Bauteile |
|
ST95040M6TR Datenblatt(PDF) 10 Page - STMicroelectronics |
|
ST95040M6TR Datenblatt(HTML) 10 Page - STMicroelectronics |
10 / 18 page DATA PROTECTION AND PROTOCOL SAFETY – All inputs are protected against noise, see Table 6. – Non valid S and HOLD transitions are not taken into account. – S must come high at the proper clock count in order to start a non-volatile write cycle (in the memory array or in the status register), that is the Chip Select S mustrise during the clock pulse following the introduction of a multiple of 8 bits. – Access to the memory array during non-volatile programming cycle is ignored; however, the pro- gramming cycle continues. – After any of the operations WREN, WRDI, RDSR is completed, the chip enters a wait state and waits for a deselect. – The write enable latch is reset upon power-up. – The write enable latch is reset when W is brought low. INITIAL DELIVERY STATE The device is delivered with the memory array in a fully erased state (all data set at all ”1’s” or FFh). The block protect bits are initialized to 00. AI01446 MASTER ST95xxx D Q C CQ D S ST95xxx CQ D S ST95xxx CQ D S CS3 CS2 CS1 Figure 12. EEPROM and SPI Bus 10/18 ST95040, ST95020, ST95010 |
Ähnliche Teilenummer - ST95040M6TR |
|
Ähnliche Beschreibung - ST95040M6TR |
|
|
Link URL |
Privatsphäre und Datenschutz |
ALLDATASHEETDE.COM |
War ALLDATASHEET hilfreich? [ DONATE ] |
Über Alldatasheet | Werbung | Kontakt | Privatsphäre und Datenschutz | Linktausch | Hersteller All Rights Reserved©Alldatasheet.com |
Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
Family Site : ic2ic.com |
icmetro.com |