Datenblatt-Suchmaschine für elektronische Bauteile
  German  ▼
ALLDATASHEETDE.COM

X  

CAR1248TNBCXZ01A Datenblatt(PDF) 4 Page - Lineage Power Corporation

Teilenummer CAR1248TNBCXZ01A
Bauteilbeschribung  Universal input with PFC Constant power characteristic 3 front panel LEDs: 1-input;2-output; 3 - fault
Download  8 Pages
Scroll/Zoom Zoom In 100%  Zoom Out
Hersteller  LINEAGEPOWER [Lineage Power Corporation]
Direct Link  http://www.lineagepower.com
Logo LINEAGEPOWER - Lineage Power Corporation

CAR1248TNBCXZ01A Datenblatt(HTML) 4 Page - Lineage Power Corporation

  CAR1248TNBCXZ01A Datasheet HTML 1Page - Lineage Power Corporation CAR1248TNBCXZ01A Datasheet HTML 2Page - Lineage Power Corporation CAR1248TNBCXZ01A Datasheet HTML 3Page - Lineage Power Corporation CAR1248TNBCXZ01A Datasheet HTML 4Page - Lineage Power Corporation CAR1248TNBCXZ01A Datasheet HTML 5Page - Lineage Power Corporation CAR1248TNBCXZ01A Datasheet HTML 6Page - Lineage Power Corporation CAR1248TNBCXZ01A Datasheet HTML 7Page - Lineage Power Corporation CAR1248TNBCXZ01A Datasheet HTML 8Page - Lineage Power Corporation  
Zoom Inzoom in Zoom Outzoom out
 4 / 8 page
background image
GE
CAR1248TN series rectifier
Input: 90Vac to 264Vac; Output: -54Vdc @ 1200W
November 20, 2012
©2012 General Electric Company. All rights reserved.
Page 4
EMC
Parameter
Criteria
Standard
Level
Test
AC input
Conducted emissions
EN55022, FCC Docket 20780 part 15, subpart J
A
0.15 – 30MHz
Radiated emissions**
EN55022
A
30 – 10000MHz
Voltage dips
EN61000-4-11
A
-30%, 10ms
B
-60%, 100ms
B
-100%, 5sec
Voltage surge
EN61000-4-5
A
4kV, 1.2/50µs, common mode
A
2kV, 1.2/50µs, differential mode
immunity
Fast transients
EN61000-4-4
B
5/50ns, 2kV (common mode)
Enclosure immunity
Conducted RF fields
EN61000-4-6
A
130dBµV, 0.15-80MHz, 80% AM
Radiated RF fields
EN61000-4-3
A
10V/m, 80-1000MHz, 80% AM
ENV 50140
A
ESD
EN61000-4-2
B
4kV contact, 8kV air
** Radiated emissions compliance is contingent upon the final system configuration.
Status and Control
Signal Definitions
All signals and outputs are referenced to Output return. These
include ‘Vstb return’ and ‘Signal return’.
Input Signals
Voltage programming (Vprog): An analog voltage on this signal
can vary the output voltage from -42Vdc to -58Vdc. The
equation of this signal is:
Vout = 20x (Vprog) 2.1 < Vprog < 2.9
If Vprog is ≥ 4V, or left open the programming signal is ignored
and the unit output is set at the setpoint of -54Vdc.
Load share (Ishare): Single wire analog signal between power
supplies connected in parallel. The Ishare pins should be tied
together for power supplies. No resistors or capacitors should
get connected to this pin.
Remote ON/OFF: Controls the presence of the main -54Vdc
output voltage. This is an open collector, TTL level control
signal. This signal needs to be pulled HI externally through a
resistor. Maximum collector voltage is 12Vdc, maximum sink
current is 1mA. Logic 1 turns ON the -54Vdc output, while a
Logic 0 turns OFF the -54Vdc output.
A turn OFF command either through this signal or firmware
commanded would turn OFF the -54V output.
Enable: This is a short signal pin that controls the presence of
the -54Vdc main output. This pin should be connected to
‘output return’ on the system side of the output connector. The
purpose of this pin is to ensure that the output turns ON after
engagement of the power blades and turns OFF prior to
disengagement of the power blades.
Write protect (WP): This signal protects the contents of the
external EEPROM. When left open the EEPROM is write
protected. A LO permits writing to the EEPROM. This signal is
pulled HI internally by the power supply.
Output signals
Output current monitor (Imon): A voltage level proportional to
the output current is present on this pin. The signal level is
0. 2V per amp ± 0.25V.
AC OK: TTL compatible open collector. Maximum sink current
20mA, max voltage is 12Vdc. A (HI) on this signal indicates
that the input voltage is present within limits.
DC OK: TTL compatible, open collector. Maximum sink
current 20mA, max voltage is 12Vdc. A (HI) on this signal
indicates that the output voltage is present.
Over temp warning: TTL compatible, open collector.
Maximum sink current 20mA, max voltage is 12Vdc. A (HI) on
this signal indicates that temperatures are normal.
If an over temperature should occur, this signal would delay
pulling LO for approximately 10 seconds. The unit would
restart if internal temperatures recover within normal
operational levels.
Fault: TTL compatible, open collector. Maximum sink current
20mA, max voltage is 12Vdc. A (HI) on this signal indicates
that no faults are present.
This signal activates for OTP, OVP, or AC fault.
PS Present: Connected to ‘output return’. Its intent is to
indicate to the system that a power supply is present. This
signal may need to be pulled HI externally through a resistor.
Interrupt: A TTL compatible status signal, representing the
SMBusAlert# feature of the i2C protocol in the power supply.
This signal needs to be pulled HI externally through a resistor.
Maximum sink current ≤ 4mA and the pull up resistor should
be tied to <5Vdc. Open collector (HI) on this signal indicates
that no Interrupt has been triggered.


Ähnliche Teilenummer - CAR1248TNBCXZ01A

HerstellerTeilenummerDatenblattBauteilbeschribung
logo
Lineage Power Corporati...
CAR1248TN LINEAGEPOWER-CAR1248TN Datasheet
935Kb / 2P
   1200 Watt 48V Rectifier Power Supply
More results

Ähnliche Beschreibung - CAR1248TNBCXZ01A

HerstellerTeilenummerDatenblattBauteilbeschribung
logo
Lineage Power Corporati...
CAR1248FP LINEAGEPOWER-CAR1248FP_14 Datasheet
264Kb / 11P
   Universal input with PFC Constant power characteristic 3 front panel LEDs: 1-input;2-output; 3 - fault
CAR2024FP LINEAGEPOWER-CAR2024FP_14 Datasheet
261Kb / 7P
   Universal input with PFC Constant power characteristic front panel LEDs: input, output, fault
CAR2012TE LINEAGEPOWER-CAR2012TE Datasheet
444Kb / 20P
   Universal input with PFC Constant power characteristic 2 front panel LEDs: 1-input;2
CAR1612FP LINEAGEPOWER-CAR1612FP_14 Datasheet
293Kb / 7P
   Universal input with PFC Constant power characteristic 2 front panel LED 1-input LED 2-[output, fault, over temp]
logo
Mitsumi Electronics, Co...
MM1111 MITSUMI-MM1111 Datasheet
231Kb / 10P
   2-Input 1-Output Video Switch / 3-Input 1-Output Video Switch
logo
New Japan Radio
NJM2535 NJRC-NJM2535 Datasheet
196Kb / 4P
   3-INPUT 1-OUTPUT VIDEO SWITCH??????
NJM2534 NJRC-NJM2534 Datasheet
175Kb / 4P
   3-INPUT 1-OUTPUT VIDEO SWITCH????
NJM2521 NJRC-NJM2521 Datasheet
127Kb / 3P
   3-INPUT 1-OUTPUT AUDIO SWITCH?
logo
Mitsumi Electronics, Co...
MM1238 MITSUMI-MM1238 Datasheet
91Kb / 6P
   3-Input 2-Output 3-Circuit Video Switch
logo
HITRON ELECTRONICS CORP...
HVP950 HITRON-HVP950 Datasheet
129Kb / 2P
   UNIVERSAL INPUT HARMONIC CORRECTION(PFC)
More results


Html Pages

1 2 3 4 5 6 7 8


Datenblatt Download

Go To PDF Page


Link URL




Privatsphäre und Datenschutz
ALLDATASHEETDE.COM
War ALLDATASHEET hilfreich?  [ DONATE ] 

Über Alldatasheet   |   Werbung   |   Kontakt   |   Privatsphäre und Datenschutz   |   Linktausch   |   Hersteller
All Rights Reserved©Alldatasheet.com


Mirror Sites
English : Alldatasheet.com  |   English : Alldatasheet.net  |   Chinese : Alldatasheetcn.com  |   German : Alldatasheetde.com  |   Japanese : Alldatasheet.jp
Russian : Alldatasheetru.com  |   Korean : Alldatasheet.co.kr  |   Spanish : Alldatasheet.es  |   French : Alldatasheet.fr  |   Italian : Alldatasheetit.com
Portuguese : Alldatasheetpt.com  |   Polish : Alldatasheet.pl  |   Vietnamese : Alldatasheet.vn
Indian : Alldatasheet.in  |   Mexican : Alldatasheet.com.mx  |   British : Alldatasheet.co.uk  |   New Zealand : Alldatasheet.co.nz
Family Site : ic2ic.com  |   icmetro.com