Datenblatt-Suchmaschine für elektronische Bauteile
LL-484WM1F-W5-1J_15 Datenblatt(Datasheet) 8 Page - Lucky Light Electronic
LUCKY-LIGHT [Lucky Light Electronic]
Spec No.: A037 X440
Rev No.: V.2
Page: 8 OF 8
Lucky Light Electronics Co., Ltd.
Please read the following notes before using the datasheets:
Customer must apply resistors for protection, otherwise slight voltage shift will cause big current change
(Burn out will happen).
2.1 Do not open moisture proof bag before the products are ready to use.
2.2 Before opening the package, the LEDs should be kept at 30℃ or less and 90%RH or less.
2.3 The LEDs should be used within a year.
2.4 After opening the package, the LEDs should be kept at 30℃ or less and 70%RH or less.
2.5 The LEDs should be used within 168 hours (7 days) after opening the package.
3. Soldering Condition
3.1 Pb-free solder temperature profile.
3.2 Reflow soldering should not be done more than two times.
3.3 When soldering, do not put stress on the LEDs during heating.
3.4 After soldering, do not warp the circuit board.
4. Soldering Iron
Each terminal is to go to the tip of soldering iron temperature less than 260℃ for 5 seconds within once in
less than the soldering iron capacity 25W. Leave two seconds and more intervals, and do soldering of each
terminal. Be careful because the damage of the product is often started at the time of the hand sold
Repair should not be done after the LEDs have been soldered. When repairing is unavoidable, a double-head
soldering iron should be used (as below figure). It should be confirmed beforehand whether the
characteristics of the LEDs will or will not be damaged by repairing.
6. Caution in ESD
Static Electricity and surge damages the LED. It is recommend to use a wrist band or anti-electrostatic glove
when handling the LED. All devices equipment and machinery must be properly grounded.
War ALLDATASHEET hilfreich?
[ Spenden ]
Privatsphäre und Datenschutz
All Rights Reserved©
|   Chinese :
| German :
| Japanese :
| Russian :
| Spanish :
| French :
| Italian :
| Portuguese :
| Polish :