Datenblatt-Suchmaschine für elektronische Bauteile |
|
TS30111-M033 Datenblatt(PDF) 4 Page - Semtech Corporation |
|
TS30111-M033 Datenblatt(HTML) 4 Page - Semtech Corporation |
4 / 21 page TS30111 Final Datasheet Rev 1.0 June 2, 2015 www.semtech.com 4 of 21 Semtech Absolute Maximum Ratings Over operating free–air temperature range unless otherwise noted(1, 2) Parameter Value Unit VCC -0.3 to 18 V BST -0.3 to (VCC+6) V VSW -1 to 18 V EN, PG, FB -0.3 to 6 V Electrostatic Discharge – Human Body Model +/-2k V Electrostatic Discharge – Charge Device Model +/-500 V Lead Temperature (soldering, 10 seconds) 260 °C Notes: (1) Stresses beyond those listed under “absolute maximum ratings” may cause permanent damage to the device. These are stress ratings only and functional operation of the device at these or any other conditions beyond those indicated under “recommended operating con- ditions” is not implied. Exposure to absolute–maximum–rated conditions for extended periods may affect device reliability. (2) All voltage values are with respect to network ground terminal. Thermal Characteristics Symbol Parameter Value Unit θ JA Thermal Resistance Junction to Air (Note 1) 50 °C/W T STG Storage Temperature Range -65 to 150 °C T J MAX Maximum Junction Temperature 150 °C T J Operating Junction Temperature Range -40 to 125 °C Note 1: Assumes 16LD 3x3 QFN with hi-K JEDEC board and 13.5 inch2 of 1 oz Cu Recommended Operating Conditions Symbol Parameter Min Typ Max Unit VCC Input Operating Voltage 4.5 12 16 V C BST Bootstrap Capacitor 17.6 22 26.4 nF L OUT Output Filter Inductor Typical Value (Note 1) 3.3 uH C OUT Output Filter Capacitor Typical Value (Note 2) 22 uF C OUT-ESR Output Filter Capacitor ESR 2 100 mΩ C BYPASS Input Supply Bypass Capacitor Typical Value (Note 3) 8 10 uF Note 1: For best performance, an inductor with a saturation current rating higher than the maximum VOUT load requirement plus the inductor current ripple. Note 2: For best performance, a low ESR ceramic capacitor should be used. Note 3: For best performance, a low ESR ceramic capacitor should be used. If C BYPASS is not a low ESR ceramic capacitor, a 0.1uF ceramic capacitor should be added in parallel to C BYPASS. |
Ähnliche Teilenummer - TS30111-M033 |
|
Ähnliche Beschreibung - TS30111-M033 |
|
|
Link URL |
Privatsphäre und Datenschutz |
ALLDATASHEETDE.COM |
War ALLDATASHEET hilfreich? [ DONATE ] |
Über Alldatasheet | Werbung | Kontakt | Privatsphäre und Datenschutz | Linktausch | Hersteller All Rights Reserved©Alldatasheet.com |
Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
Family Site : ic2ic.com |
icmetro.com |