Datenblatt-Suchmaschine für elektronische Bauteile |
|
LM1882 Datenblatt(PDF) 6 Page - National Semiconductor (TI) |
|
|
LM1882 Datenblatt(HTML) 6 Page - National Semiconductor (TI) |
6 / 16 page Addressing Logic (Continued) LOAD will load the first byte of data. Auto Incrementing is disabled on the falling edge of LOAD after ADDRDATA and LHBYTE goes low. Manual Addressing Mode Cycle # Load Falling Edge Load Rising Edge 1 Enable Manual Addressing Load Address m 2 Enable Lbyte Data Load Load Lbyte m 3 Enable Hbyte Data Load Load Hbyte m 4 Enable Manual Addressing Load Address n 5 Enable Lbyte Data Load Load Lbyte n 6 Enable Hbyte Data Load Load Hbyte n Auto Addressing Mode Cycle # Load Falling Edge Load Rising Edge 1 Enable Auto Addressing Load Start Address n 2 Enable Lbyte Data Load Load Lbyte (n) 3 Enable Hbyte Data Load Load Hbyte (n); Inc Counter 4 Enable Lbyte Data Load Load Lbyte (n+1) 5 Enable Hbyte Data Load Load Hbyte (n+1); Inc Counter 6 Enable Manual Addressing Load Address ADDRDEC LOGIC The ADDRDEC logic decodes the current address and gen- erates the enable signal for the appropriate register. The en- able values for the registers and counters change on the fall- ing edge of LOAD. Two types of ADDRDEC logic is enabled by 2 pair of addresses, Addresses 22 or 54 (Vectored Re- start logic) and Addresses 23 or 55 (Vectored Clear logic). Loading these addresses will enable the appropriate logic and put the part into either a Restart (all counter registers are reinitialized with preprogrammed data) or Clear (all registers are cleared to zero) state. Reloading the same ADDRDEC address will not cause any change in the state of the part. The outputs during these states are frozen and the internal CLOCK is disabled. Clocking the part during a Vectored Re- start or Vectored Clear state will have no effect on the part. To resume operation in the new state, or disable the Vec- tored Restart or Vectored Clear state, another non-ADDRDEC address must be loaded. Operation will be- gin in the new state on the rising edge of the non-ADDRDEC load pulse. It is recommended that an unused address be loaded following an ADDRDEC operation to prevent data registers from accidentally being corrupted. The following Addresses are used by the device. Address 0 Status Register REG0 Address 1–18Data Registers REG1–REG18 DS100232-7 DS100232-8 www.national.com 6 |
Ähnliche Teilenummer - LM1882 |
|
Ähnliche Beschreibung - LM1882 |
|
|
Link URL |
Privatsphäre und Datenschutz |
ALLDATASHEETDE.COM |
War ALLDATASHEET hilfreich? [ DONATE ] |
Über Alldatasheet | Werbung | Kontakt | Privatsphäre und Datenschutz | Linktausch | Hersteller All Rights Reserved©Alldatasheet.com |
Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
Family Site : ic2ic.com |
icmetro.com |