Datenblatt-Suchmaschine für elektronische Bauteile |
|
AD7150 Datenblatt(PDF) 23 Page - Analog Devices |
|
AD7150 Datenblatt(HTML) 23 Page - Analog Devices |
23 / 29 page AD7150 Rev. 0 | Page 22 of 28 If a repeated start condition is encountered after the address pointer byte, all peripherals connected to the bus respond exactly as outlined previously for a start condition; that is, a repeated start condition is treated the same as a start condition. When a master device issues a stop condition, it relinquishes control of the bus, allowing another master device to take control of the bus. Therefore, a master wanting to retain control of the bus issues successive start conditions known as repeated start conditions. AD7150 RESET To reset the AD7150 without having to reset the entire serial bus, an explicit reset command is provided. This uses a particular address pointer word as a command word to reset the part and upload all default settings. The AD7150 does not respond to the serial bus commands (do not acknowledge) during the default values upload for approximately 2 ms. The reset command address word is 0xBF. GENERAL CALL When a master issues a slave address consisting of seven 0s with the eighth bit (R/W bit) set to 0, this is known as the general call address. The general call address is for addressing every device connected to the serial bus. The AD7150 acknowledges this address and reads in the following data byte. If the second byte is 0x06, the AD7150 is reset, completely uploading all default values. The AD7150 does not respond to the serial bus commands (do not acknowledge) during the default values upload for approximately 2 ms. The AD7150 does not acknowledge any other general call commands. 1–7 8 9 1–7 8 9 1–7 8 9 P S START ADDR R/W ACK SUBADDRESS ACK DATA ACK STOP SDATA SCLOCK Figure 42. Bus Data Transfer DATA A(S) S SLAVE ADDR A(S) SUB ADDR A(S) LSB = 0 LSB = 1 DATA P S SLAVE ADDR A(S) SUB ADDR A(S) S SLAVE ADDR A(S) DATA A(M) DATA P WRITE SEQUENCE READ SEQUENCE A(S) = NO ACKNOWLEDGE BY SLAVE A(M) = NO ACKNOWLEDGE BY MASTER A(S) = ACKNOWLEDGE BY SLAVE A(M) = ACKNOWLEDGE BY MASTER S = START BIT P = STOP BIT A(S) A(M) Figure 43. Write and Read Sequences |
Ähnliche Teilenummer - AD7150_17 |
|
Ähnliche Beschreibung - AD7150_17 |
|
|
Link URL |
Privatsphäre und Datenschutz |
ALLDATASHEETDE.COM |
War ALLDATASHEET hilfreich? [ DONATE ] |
Über Alldatasheet | Werbung | Kontakt | Privatsphäre und Datenschutz | Linktausch | Hersteller All Rights Reserved©Alldatasheet.com |
Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
Family Site : ic2ic.com |
icmetro.com |