Electrical Characteristics

(Notes 2, 8) Limits in standard typeface and typical values apply for T

Limits in boldface type apply over the operating junction temperature range. Unless otherwise specified: 2.6

≤ V

IN

≤ 5.5V,

V(EN) = V

(Continued)

Note 4: Thermal shutdown circuitry protects the device from permanent damage.

Note 5: The Human body model is a 100 pF capacitor discharged through a 1.5 k

Ω resistor into each pin. The machine model is a 200pF capacitor discharged

directly into each pin.

Note 7: Junction-to-ambient thermal resistance is a highly application and board-layout dependent. In applications where high maximum power dissipation exists,

special care must be paid to thermal dissipation issues. Fore more information on these topics, please refer to the Power Dissipation section of this datasheet.

Note 8: All room temperature limits are 100% tested or guaranteed through statistical analysis. All limits at temperature extremes are guaranteed by correlation

using standard Statistical Quality Control methods (SQC). All limits are used to calculate Average Outgoing Quality Level (AOQL). Typical numbers are not

guaranteed, but do represent the most likely norm.

table for available options.

Note 12: Turn-on time is measured from when the EN signal is pulled high until the output voltage crosses 90% of its final value.

Block Diagram

20044403

www.national.com

4