SN74GTLP2033

8-BIT LVTTL-TO-GTLP ADJUSTABLE-EDGE-RATE REGISTERED TRANSCEIVER

WITH SPLIT LVTTL PORT AND FEEDBACK PATH

SCES352C – JUNE 2001 – REVISED SEPTEMBER 2001

8

POST OFFICE BOX 655303

recommended operating conditions (see Notes 4 through 7)

MIN

NOM

MAX

UNIT

VCC,

BIAS VCC

Supply voltage

3.15

3.3

3.45

V

VTT

Termination voltage

GTL

1.14

1.2

1.26

V

VTT

Termination voltage

GTLP

1.35

1.5

1.65

V

VREF

Reference voltage

GTL

0.74

0.8

0.87

V

VREF

Reference voltage

GTLP

0.87

1

1.1

V

VI

Input voltage

B port

VTT

V

VI

Input voltage

Except B port and VREF

VCC

5.5

V

VIH

High level input voltage

B port

VREF+0.05

V

VIH

High-level input voltage

Except B port

2

V

VIL

Low level input voltage

B port

VREF–0.05

V

VIL

Low-level input voltage

Except B port

0.8

V

IIK

Input clamp current

–18

mA

IOH

High-level output current

AO

–24

mA

IOL

Low level output current

AO

24

mA

IOL

Low-level output current

B port

100

mA

∆t/∆v

Input transition rise or fall rate

Outputs enabled

10

ns/V

∆t/∆VCC

Power-up ramp rate

20

µs/V

TA

Operating free-air temperature

–40

85

°C

NOTES:

4. All unused control and B-port inputs of the device must be held at VCC or GND to ensure proper device operation. Refer to the TI

application report, Implications of Slow or Floating CMOS Inputs, literature number SCBA004.

5. Proper connection sequence for use of the B-port I/O precharge feature is GND and BIAS VCC = 3.3 V first, I/O second, and

VCC = 3.3 V last, because the BIAS VCC precharge circuitry is disabled when any VCC pin is connected. The control and VREF inputs

can be connected anytime, but normally are connected during the I/O stage. If B-port precharge is not required, any connection

sequence is acceptable but, generally, GND is connected first.

6. VTT and RTT can be adjusted to accommodate backplane impedances if the dc recommended IOL ratings are not exceeded.

7. VREF can be adjusted to optimize noise margins, but normally is two-thirds VTT. TI-OPC circuitry is enabled in the A-to-B direction

and is activated when VTT > 0.7 V above VREF. If operated in the A-to-B direction, VREF should be set to within 0.6 V of VTT to

minimize current drain.