2 GHz, Ultralow Distortion,

Differential RF/IF Amplifier

Data Sheet

AD8352

Rev. C

Document Feedback

Information furnished by Analog Devices is believed to be accurate and reliable. However, no

responsibilityisassumedbyAnalogDevicesforitsuse,norforanyinfringementsofpatentsorother

rightsofthirdpartiesthatmayresultfromitsuse.Specificationssubjecttochangewithoutnotice.No

license is granted by implication or otherwise under any patent or patent rights of Analog Devices.

Trademarksandregisteredtrademarksarethepropertyoftheirrespectiveowners.

One Technology Way, P.O. Box 9106, Norwood, MA 02062-9106, U.S.A.

Tel: 781.329.4700

©2006–2018 Analog Devices, Inc. All rights reserved.

Technical Support

www.analog.com

FEATURES

Single resistor and capacitor distortion adjust

Differential or single-ended input to differential output

Low broadband distortion

10 MHz: −86 dBc HD2, −82 dBc HD3

70 MHz: −84 dBc HD2, −82 dBc HD3

190 MHz: −81 dBc HD2, −87 dBc HD3

OIP3 of 41 dBm at 150 MHz

Slew rate: 8 V/ns

Fast settling and overdrive recovery of <2 ns

Single-supply operation: 3 V to 5.5 V

Low power dissipation: 37 mA typical at 5 V

Power-down capability: 5 mA at 5 V

Fabricated using the high speed XFCB3 SiGe process

APPLICATIONS

Differential ADC drivers

Single-ended-to-differential conversion

RF/IF gain blocks

SAW filter interfacing

FUNCTIONAL BLOCK DIAGRAM

ENB

VCM

VOP

VON

GND

RGP

RDP

RDN

RGN

VIP

VIN

BIAS CELL

VCC

AD8352

+

–

Figure 1.

GENERAL DESCRIPTION

The AD8352 is a high performance differential amplifier

optimized for RF and IF applications. It achieves better than

80 dB SFDR performance at frequencies up to 200 MHz, and

65 dB beyond 500 MHz, making it an ideal driver for high

speed 12-bit to 16-bit analog-to-digital converters (ADCs).

Unlike other wideband differential amplifiers, the AD8352 has

inputs. As a result, the AD8352 maintains a constant 3 kΩ input

resistance for gains of 3 dB to 25 dB, easing matching and input

drive requirements. The AD8352 has a nominal 100 Ω differential

output resistance.

The device is optimized for wideband, low distortion performance

at frequencies beyond 500 MHz. These attributes, together with

its wide gain adjust capability, make this device the amplifier of

choice for general-purpose IF and broadband applications

where low distortion, noise, and power are critical. It is ideally

suited for driving not only ADCs but also mixers, pin diode

attenuators, surface acoustic wave (SAW) filters, and multi-

element discrete devices. The device is available in a compact

3 mm × 3 mm, 16-lead LFCSP and operates over a temperature

range of −40°C to +85°C.

–60

–100

20

220

FREQUENCY (MHz)

–65

–70

–75

–80

–85

–90

–95

44

28

42

40

38

36

34

32

30

40

60

80

100

120

140

160

180

200

Figure 2. Third Harmonic Distortion (HD3) and IP3 vs.

Frequency, Measured Differentially