ST7DALI datasheet(52/141 Pages) STMICROELECTRONICS

Teilenummer	ST7DALI

Bauteilbeschribung	8-BIT MCU WITH SINGLE VOLTAGE FLASH MEMORY, DATA EEPROM, ADC, TIMERS, SPI, DALI

Download	141 Pages

Scroll/Zoom	100%

Hersteller	STMICROELECTRONICS [STMicroelectronics]

Direct Link	http://www.st.com

Logo

52 / 141 page

ST7DALI

52/141

WATCHDOG TIMER (Cont’d)

The application program must write in the CR reg-

ister at regular intervals during normal operation to

prevent an MCU reset. This downcounter is free-

running: it counts down even if the watchdog is

disabled. The value to be stored in the CR register

must be between FFh and C0h (see Table 12

.Watchdog Timing):

– The WDGA bit is set (watchdog enabled)

– The T6 bit is set to prevent generating an imme-

diate reset

– The T[5:0] bits contain the number of increments

which represents the time delay before the

watchdog produces a reset.

Following a reset, the watchdog is disabled. Once

activated it cannot be disabled, except by a reset.

The T6 bit can be used to generate a software re-

set (the WDGA bit is set and the T6 bit is cleared).

If the watchdog is activated, the HALT instruction

will generate a Reset.

Table 12.Watchdog Timing

Notes:

1. The timing variation shown in Table 12 is due to

the unknown status of the prescaler when writing

to the CR register.

2. The number of CPU clock cycles applied during

the RESET phase (256 or 4096) must be taken

into account in addition to these timings.

11.1.4 Hardware Watchdog Option

If Hardware Watchdog is selected by option byte,

the watchdog is always active and the WDGA bit in

the CR is not used.

Refer to the Option Byte description in section 15

on page 130.

11.1.4.1 Using Halt Mode with the WDG

(WDGHALT option)

If Halt mode with Watchdog is enabled by option

byte (No watchdog reset on HALT instruction), it is

recommended before executing the HALT instruc-

tion to refresh the WDG counter, to avoid an unex-

pected WDG reset immediately after waking up

the microcontroller. Same behavior in active-halt

mode.

fCPU = 8MHz

WDG

Counter

Code

min

[ms]

max

[ms]

C0h

1

2

FFh

127

128

1

Ähnliche Beschreibung - ST7DALI

Hersteller	Teilenummer	Datenblatt	Bauteilbeschribung
STMicroelectronics	ST7LITE2	1Mb / 131P	8-BIT MCU WITH SINGLE VOLTAGE FLASH MEMORY, DATA EEPROM, ADC, TIMERS, SPI August 2003 Rev. 2.0
	ST7LITE0	1Mb / 122P	8-BIT MCU WITH SINGLE VOLTAGE FLASH MEMORY, DATA EEPROM, ADC, TIMERS, SPI August 2003 Rev. 2.4
	ST7FLIT19BF1B6	2Mb / 159P	8-BIT MCU WITH SINGLE VOLTAGE FLASH MEMORY, DATA EEPROM, ADC, 5 TIMERS, SPI
	ST7LITE1XB	2Mb / 157P	8-BIT MCU WITH SINGLE VOLTAGE FLASH MEMORY, DATA EEPROM, ADC, 5 TIMERS, SPI
	ST7LITE1XB	2Mb / 159P	8-BIT MCU WITH SINGLE VOLTAGE FLASH MEMORY, DATA EEPROM, ADC, 5 TIMERS, SPI
	ST7LITE1	1Mb / 131P	8-BIT MCU WITH SINGLE VOLTAGE FLASH MEMORY, DATA EEPROM, ADC, 4 TIMERS, SPI December 2004 Rev. 2.0
	ST7FLIT15BF1M6	2Mb / 159P	8-BIT MCU WITH SINGLE VOLTAGE FLASH MEMORY, DATA EEPROM, ADC, 5 TIMERS, SPI
	ST7L05	1Mb / 104P	8-bit MCU for automotive with single voltage Flash memory, data EEPROM, ADC, timers, SPI
	ST7LITE3	3Mb / 167P	8-BIT MCU WITH SINGLE VOLTAGE FLASH, DATA EEPROM, ADC, TIMERS, SPI, LINSCI
	ST7LITE3XF2	2Mb / 173P	8-bit MCU with single voltage Flash, data EEPROM, ADC, timers, SPI, LINSCI?

More results

ST7DALI Datenblatt(PDF) 52 Page - STMicroelectronics

ST7DALI Datenblatt(HTML) 52 Page - STMicroelectronics

Ähnliche Teilenummer - ST7DALI

Ähnliche Beschreibung - ST7DALI

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Datenblatt Download

Link URL