ST7DALI datasheet(33/141 Pages) STMICROELECTRONICS

Teilenummer	ST7DALI

Bauteilbeschribung	8-BIT MCU WITH SINGLE VOLTAGE FLASH MEMORY, DATA EEPROM, ADC, TIMERS, SPI, DALI

Download	141 Pages

Scroll/Zoom	100%

Hersteller	STMICROELECTRONICS [STMicroelectronics]

Direct Link	http://www.st.com

Logo

33 / 141 page

ST7DALI

33/141

SYSTEM INTEGRITY MANAGEMENT (Cont’d)

7.6.4 Register Description

SYSTEM INTEGRITY (SI) CONTROL/STATUS REGISTER (SICSR)

Read/Write

Reset Value: 0000 0xx0 (0xh)

Bit 7:5 = Reserved, must be kept cleared.

Bit 4 = WDGRF Watchdog reset flag

This bit indicates that the last Reset was generat-

ed by the Watchdog peripheral. It is set by hard-

ware (watchdog reset) and cleared by software

(writing zero) or an LVD Reset (to ensure a stable

cleared state of the WDGRF flag when CPU

starts).

Combined with the LVDRF flag information, the

flag description is given by the following table.

Bit 3 = LOCKED PLL Locked Flag

This bit is set and cleared by hardware. It is set au-

tomatically when the PLL reaches its operating fre-

quency.

0: PLL not locked

1: PLL locked

Bit 2 = LVDRF LVD reset flag

This bit indicates that the last Reset was generat-

ed by the LVD block. It is set by hardware (LVD re-

set) and cleared by software (by reading). When

the LVD is disabled by OPTION BYTE, the LVDRF

bit value is undefined.

Bit 1 = AVDF Voltage Detector flag

This read-only bit is set and cleared by hardware.

If the AVDIE bit is set, an interrupt request is gen-

erated when the AVDF bit is set. Refer to Figure

18 and to Section 7.6.2.1 for additional details.

0: VDD over AVD threshold

1: VDD under AVD threshold

Bit 0 = AVDIE Voltage Detector interrupt enable

This bit is set and cleared by software. It enables

an interrupt to be generated when the AVDF flag is

set. The pending interrupt information is automati-

cally cleared when software enters the AVD inter-

rupt routine.

0: AVD interrupt disabled

1: AVD interrupt enabled

Application notes

The LVDRF flag is not cleared when another RE-

SET type occurs (external or watchdog), the

LVDRF flag remains set to keep trace of the origi-

nal failure.

In this case, a watchdog reset can be detected by

software while an external reset can not.

70

00

0

WDG

RF

LOCKED LVDRF AVDF AVDIE

RESET Sources

LVDRF

WDGRF

External RESET pin

0

Watchdog

0

1

LVD

1

X

1

Ähnliche Beschreibung - ST7DALI

Hersteller	Teilenummer	Datenblatt	Bauteilbeschribung
STMicroelectronics	ST7LITE2	1Mb / 131P	8-BIT MCU WITH SINGLE VOLTAGE FLASH MEMORY, DATA EEPROM, ADC, TIMERS, SPI August 2003 Rev. 2.0
	ST7LITE0	1Mb / 122P	8-BIT MCU WITH SINGLE VOLTAGE FLASH MEMORY, DATA EEPROM, ADC, TIMERS, SPI August 2003 Rev. 2.4
	ST7FLIT19BF1B6	2Mb / 159P	8-BIT MCU WITH SINGLE VOLTAGE FLASH MEMORY, DATA EEPROM, ADC, 5 TIMERS, SPI
	ST7LITE1XB	2Mb / 157P	8-BIT MCU WITH SINGLE VOLTAGE FLASH MEMORY, DATA EEPROM, ADC, 5 TIMERS, SPI
	ST7LITE1XB	2Mb / 159P	8-BIT MCU WITH SINGLE VOLTAGE FLASH MEMORY, DATA EEPROM, ADC, 5 TIMERS, SPI
	ST7LITE1	1Mb / 131P	8-BIT MCU WITH SINGLE VOLTAGE FLASH MEMORY, DATA EEPROM, ADC, 4 TIMERS, SPI December 2004 Rev. 2.0
	ST7FLIT15BF1M6	2Mb / 159P	8-BIT MCU WITH SINGLE VOLTAGE FLASH MEMORY, DATA EEPROM, ADC, 5 TIMERS, SPI
	ST7L05	1Mb / 104P	8-bit MCU for automotive with single voltage Flash memory, data EEPROM, ADC, timers, SPI
	ST7LITE3	3Mb / 167P	8-BIT MCU WITH SINGLE VOLTAGE FLASH, DATA EEPROM, ADC, TIMERS, SPI, LINSCI
	ST7LITE3XF2	2Mb / 173P	8-bit MCU with single voltage Flash, data EEPROM, ADC, timers, SPI, LINSCI?

More results

ST7DALI Datenblatt(PDF) 33 Page - STMicroelectronics

ST7DALI Datenblatt(HTML) 33 Page - STMicroelectronics

Ähnliche Teilenummer - ST7DALI

Ähnliche Beschreibung - ST7DALI

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Datenblatt Download

Link URL