ADN2892

Preliminary Technical Data

Rev. PrA| Page 10 of 12

PCB Layout

Figure 9 shows a recommended PC board layout. Use of 50 Ω

transmission lines is required for all high frequency input and

output signals to minimize reflections: PIN, NIN, OUTP and

OUTN. It is also necessary for the PIN/NIN input traces to be

matched in length, and OUTP/OUTN output traces to be

matched in length to avoid skew between the differential traces.

C1, C2, C3, and C4 are ac coupling capacitors in series with the

high speed I/O. It is recommended that components be used

such that the pad for the capacitor is the same width as the

transmission line to minimize the mismatch in the 50 Ω

transmission line at the capacitor's pads. It is recommended that

the transmission lines not change layers through vias, if

possible. For supply decoupling, the 1nF decoupling capacitor

should be placed on the same layer as the ADN2892 as close as

possible to the VCC pin. The 0.1uF capacitor can be placed on

the bottom of the PCB directly underneath the 1nF decoupling

capacitor. All high speed CML outputs are back-terminated on

chip with 50 Ω resistors connected between the output pin and

VCC. The high speed inputs, PIN and NIN, are internally

terminated with 50 Ω to an internal reference voltage.

As with any high speed mixed-signal design, take care to keep

all high speed digital traces away from sensitive analog nodes.

Soldering Guidelines for Chip Scale Package

The lands on the 16 LFCSP are rectangular. The printed circuit

board pad for these should be 0.1 mm longer than the package

land length and 0.05 mm wider than the package land width.

The land should be centered on the pad. This ensures that the

solder joint size is maximized. The bottom of the chip scale

package has a central exposed pad. The pad on the printed

circuit board should be at least as large as this exposed pad. The

user must connect the exposed pad to VEE using filled vias so

that solder does not leak through the vias during reflow. This

ensures a solid connection from the exposed pad to VEE.

1

C1

C2

C6

place C5 on

bottom of board

underneath C6

Via to C12, R2

on bottom

Vias to bottom

C8

place C7 on

bottom of board

underneath C8

C3

C4

OUTP

OUTN

PIN

NIN

double-via to GND

to reduce inductance

double-vias to reduce

inductance to supply

and GND

TO ROSA

R1,C9,C10 on bottom

~4mm

filled

vias to GND

exposed pad

transmission lines same

width as AC coupling

caps to reduce reflections

Figure 9. Recommended ADN2892 PCB Layout