ADF4193BCPZ datasheet(11/28 Pages) AD

Teilenummer	ADF4193BCPZ

Bauteilbeschribung	Low Phase Noise, Fast Settling PLL Frequency Synthesizer

Download	28 Pages

Scroll/Zoom	100%

Hersteller	AD [Analog Devices]

Direct Link	http://www.analog.com

Logo

11 / 28 page

ADF4193

Rev. B | Page 11 of 28

THEORY OF OPERATION

The ADF4193 is targeted at GSM base station requirements,

specifically to eliminate the need for ping-pong solutions. It

works based on fast lock, using a wide loop bandwidth during a

frequency change and narrowing the loop bandwidth once

frequency lock is achieved. Widening the loop bandwidth is

achieved by increasing the charge pump current. Switches are

included to change the loop filter component values to maintain

stability with the changing charge pump current. The narrow

loop bandwidth ensures that phase noise and spur specifications

are met. A differential charge pump and loop filter topology are

used to ensure that the fast lock time benefit from widening the

loop bandwidth is maintained when the loop is restored to

narrow bandwidth mode for normal operation.

REFERENCE INPUT SECTION

The reference input stage is shown in Figure 20. Switches S1 and

S2 are normally closed, and S3 is normally open. During power-

down, S3 is closed, and S1 and S2 are opened to ensure that

there is no loading of the REFIN pin. The falling edge of REFIN is

the active edge at the positive edge triggered PFD.

BUFFER

TO R COUNTER

REFIN

100k

Ω

NC

S2

S3

NO

NC

S1

POWER-DOWN

CONTROL

Figure 20. Reference Input Stage

R Counter and Doubler

The 4-bit R counter allows the input reference frequency to be

divided down to produce the reference clock to the phase

frequency detector (PFD). A toggle flip-flop can be optionally

inserted after the R counter to give a further divide-by-2. Using

this option has the additional advantage of ensuring that the

PFD reference clock has a 50/50 mark-space ratio. This ratio

gives the maximum separation between the fast lock timer

clock, which is generated off the falling edge of the PFD

reference, and the rising edge, which is the active edge in the

PFD. It is recommended that this toggle flip-flop be enabled for

all even R divide values greater than 2. It must be enabled if

dividing down a REFIN frequency that is greater than 120 MHz.

An optional doubler before the 4-bit R counter can be used for

low REFIN frequencies, up to 20 MHz. With these programmable

options, reference division ratios from 0.5 to 30 between REFIN

and the PFD are possible.

RF INPUT STAGE

The RF input stage is shown in Figure 21. It is followed by a

2-stage limiting amplifier to generate the CML clock levels

needed for the prescaler. Two prescaler options are selectable: a

4/5 and an 8/9. The 8/9 prescaler is selected for N divider values

greater than 80.

BIAS

GENERATOR

1.6V

AGND

AVDD

500

Ω

500

Ω

RFIN–

RFIN+

Figure 21. RF Input Stage

RF N Divider

The RF N divider allows a fractional division ratio in the PLL

feedback path. The integer and fractional parts of the division

are programmed using separate registers, as shown in Figure 22

and described in the INT, FRAC, and MOD Relationship

section. Integer division ratios from 26 to 255 are allowed and a

third-order, Σ-Δ modulator interpolates the fractional value

between the integer steps.

THIRD-ORDER

FRACTIONAL

INTERPOLATOR

FRAC

VALUE

MOD

REG

INT

REG

RF N DIVIDER

N = INT + FRAC/MOD

FROM RF

INPUT STAGE

TO PFD

N COUNTER

Figure 22. Fractional-N Divider

INT, FRAC, and MOD Relationship

The INT, FRAC, and MOD values, programmed through the

serial interface, make it possible to generate RF output frequencies

that are spaced by fractions of the PFD reference frequency.

The N divider value, shown inside the brackets of the following

equation for the RF VCO frequency (RFOUT), is made up of an

integer part (INT) and a fractional part (FRAC/MOD):

RFOUT = FPFD × [INT + (FRAC/MOD)]

where:

RFOUT is the output frequency of the external VCO.

FPFD is the PFD reference frequency.

ADF4193BCPZ Datenblatt(PDF) 11 Page - Analog Devices

ADF4193BCPZ Datenblatt(HTML) 11 Page - Analog Devices

Ähnliche Teilenummer - ADF4193BCPZ

Ähnliche Beschreibung - ADF4193BCPZ

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28

Datenblatt Download

Link URL