LA6504H

PS No.A0594-10/10

SANYO Semiconductor Co.,Ltd. assumes no responsibility for equipment failures that result from using

products at values that exceed, even momentarily, rated values (such as maximum ratings, operating condition

ranges, or other parameters) listed in products specifications of any and all SANYO Semiconductor Co.,Ltd.

products described or contained herein.

SANYO Semiconductor Co.,Ltd. strives to supply high-quality high-reliability products, however, any and all

semiconductor products fail or malfunction with some probability. It is possible that these probabilistic failures or

malfunction could give rise to accidents or events that could endanger human lives, trouble that could give rise

to smoke or fire, or accidents that could cause damage to other property. When designing equipment, adopt

safety measures so that these kinds of accidents or events cannot occur. Such measures include but are not

limited to protective circuits and error prevention circuits for safe design, redundant design, and structural

design.

Upon using the technical information or products described herein, neither warranty nor license shall be granted

with regard to intellectual property rights or any other rights of SANYO Semiconductor Co.,Ltd. or any third

party. SANYO Semiconductor Co.,Ltd. shall not be liable for any claim or suits with regard to a third party's

intellctual property rights which has resulted from the use of the technical information and products mentioned

above.

Information (including circuit diagrams and circuit parameters) herein is for example only; it is not guaranteed

for volume production.

Any and all information described or contained herein are subject to change without notice due to

product/technology improvement, etc. When designing equipment, refer to the "Delivery Specification" for the

SANYO Semiconductor Co.,Ltd. product that you intend to use.

In the event that any or all SANYO Semiconductor Co.,Ltd. products described or contained herein are

controlled under any of applicable local export control laws and regulations, such products may require the

export license from the authorities concerned in accordance with the above law.

No part of this publication may be reproduced or transmitted in any form or by any means, electronic or

mechanical, including photocopying and recording, or any information storage or retrieval system, or otherwise,

without the prior written consent of SANYO Semiconductor Co.,Ltd.

Sample Application Circuit

Cautions for use

1. GND

The center frame (FR) functions as a power system GND. Set it to the minimum potential together with S-GND.

2. Bypass capacitor

For power supply, connect the bypass capacitor immediately near the pin of this IC.

3. Lightening, ground fault, and short-circuit between outputs

Avoid short-circuit between the output pin and power supply (lightening), short-circuit between the output pin and

GND (ground fault), and short-circuit between output pins (load short-circuit). When mounting IC to the substrate,

pay attention to the direction of IC. Mounting in the wrong direction may cause damage to IC, and fuming in certain

cases.

This catalog provides information as of February, 2007. Specifications and information herein are subject

to change without notice.

28

27

26

25

24

23

22

21

20

19

18

17

16

15

1

2

3

4

5

6

7

8

9

10

11

12

13

14

SLED

SLED

MOTOR

FOCUS

COIL

TRACKING

COIL

LOADING

MOTOR

MUTE

TRACK IN

FOCUS

LOADING

or

SLED

1.75V

12V

M

M