10DL2C48A,10FL2C48A,U10DL2C48A,U10FL2C48A

2006-11-08

3

Handling Precaution

The absolute maximum ratings denote the absolute maximum ratings, which are rated values and must not be

exceeded during operation, even for an instant. The following are the general derating methods that we recommend

when you design a circuit with a device.

account designing a device at low temperature.

We recommend that the worst case current be no greater than 80% of the absolute maximum rating

This rating specifies the non-repetitive peak current in one cycle of a 50-Hz sine wave, condition angle 180.

Therefore, this is only applied for an abnormal operation, which seldom occurs during the lifespan of the device.

We recommend that a device be used at a Tj of below 120°C under the worst load and heat radiation conditions.

Please refer to the Rectifiers databook for further information.