EVERLIGHT ELECTRONICS CO.,LTD.

25-21UYC/S530-XX/TR8

Everlight Electronics Co., Ltd.

http://www.everlight.com

Rev.1

Page: 9 of 9

Device No:SZDSE-251-002

Prepared date:19-Aug-2005

Prepared by:Wang Zhiyong

4.Soldering Iron

Each terminal is to go to the tip of soldering iron temperature less than 350℃ for 3 seconds

within once in less than the soldering iron capacity 25W. Leave two seconds and more intervals, and

do soldering of each terminal. Be careful because the damage of the product is often started at the time

of the hand solder.

5.Repairing

Repair should not be done after the LEDs have been soldered. When repairing is unavoidable,

a double-head soldering iron should be used (as below figure). It should be confirmed beforehand

whether the characteristics of the LEDs will or will not be damaged by repairing.

EVERLIGHT ELECTRONICS CO., LTD.

Tel: 886-2-2267-2000, 2267-9936

Office: No 25, Lane 76, Sec 3, Chung Yang Rd,

Fax: 886-2267-6244, 2267-6189, 2267-6306

Tucheng, Taipei 236, Taiwan, R.O.C

http://www.everlight.com