© 2005 Fairchild Semiconductor Corporation

www.fairchildsemi.com

FAN5069 Rev. 1.1.5

3

Pin Assignment

Figure 2. Pin Assignment

Pin Description

Pin #

Name

Description

1FBLDO

2R(T)

Oscillator Set Resistor. This pin provides oscillator switching frequency adjustment. By plac-

ing a resistor (RT) from this pin to GND, the nominal 200kHz switching frequency is increased.

3ILIM

Current Limit. A resistor from this pin to GND sets the current limit.

4

SS

Soft-Start. A capacitor from this pin to GND programs the slew rate of the converter and the

LDO during initialization. It also sets the time by which the converter delays when restarting

after a fault occurs. SS has to reach 1.2V before fault shutdown feature is enabled. The LDO

is enabled when SS reaches 2.2V.

5COMP

COMP. The output of the error amplifier drives this pin.

6FB

Feedback. This pin is the inverting input of the internal error amplifier. Use this pin, in combi-

nation with the COMP pin, to compensate the feedback loop of the converter.

7EN

Enable. Enables operation when pulled to logic high. Toggling EN resets the regulator after a

latched fault condition. This is a CMOS input whose state is indeterminate if left open and

needs to be properly biased at all times.

8AGND

Analog Ground. The signal ground for IC. All internal control voltages are referred to this pin.

Tie this pin to the ground island/plane through the lowest impedance connection available.

9SW

Switching Node. Return for the high-side MOSFET driver and a current sense input. Connect

to source of high-side MOSFET and drain of low-side MOSFET.

10

HDRV

High-Side Gate Drive Output. Connect to the gate of the high-side power MOSFETs. This

pin is also monitored by the adaptive shoot-through protection circuitry to determine when the

high-side MOSFET is turned off.

11

BOOT

Bootstrap Supply Input. Provides a boosted voltage to the high-side MOSFET driver.

Connect to bootstrap capacitor as shown in Figure 1.

12

PGND

Power Ground. The return for the low-side MOSFET driver. Connect to the source of the low-

side MOSFET.

13

LDRV

Low-Side Gate Drive Output. Connect to the gate of the low-side power MOSFETs. This pin

is also monitored by the adaptive shoot-through protection circuitry to determine when the

lower MOSFET is turned off.

14

R(RAMP)

Ramp Resistor. A resistor from this pin to VIN sets the ramp amplitude and provides voltage

feed-forward.

15

VCC

VCC. Provides bias power to the IC and the drive voltage for LDRV. Bypass with a ceramic

capacitor as close to this pin as possible. This pin has a shunt regulator which draws current

when the input voltage is above 5.6V.

16

GLDO

Gate Drive for the LDO. Turned off (low) until SS is greater than 2.2V.

FAN5069

16

15

14

13

12

11

10

9

GLDO

VCC

R(RAMP)

LDRV

PGND

BOOT

HDRV

SW

FBLDO

R(T )

ILIM

SS

COMP

FB

EN

AGND

1

2

3

4

5

6

7

8