LITE-ON TECHNOLOGY CORP.

Property of Lite-on Only

ISOLATION CHARACTERISTICS

PARAMETER

SYMBOL MIN. TYP. MAX. UNIT

CONDITIONS

6 Isolation Resistance ( Input-output )

—

10

12

—

Ta=25℃, RH<45%,

6 Capacitance ( Input-output )

—

0.6

—

pF

f=1MHz

Notes,

1. AC For 1 Minute, R.H. = 40 ~ 60%

Isolation voltage shall be measured using the following method.

(1) Short between anode and cathode on the primary side and between collector and

emitter on the secondary side.

(2) The isolation voltage tester with zero-cross circuit shall be used.

(3) The waveform of applied voltage shall be a sine wave.

2. For 10 Seconds

3. Current Transfer Ratio (CTR) is defined as the ration of output collector current, Io,

to the forward LED input current, IF, times 100%.

4. Add a 0.1uF bypass capacitor connected between pin5 and pin8 is recommended.

5. Common transient immunity in logic high level is the maximum tolerance (positive)

output will remain in a logic high state (i.e., Vo>2.0V). Common mode transient

edge of the common mode pulse signal, VCM, to assure that the output will remain in a

logic low state (i.e., Vo<0.8V).

6. Device considered a two terminal device. Pins 1, 2, 3 and 4 shorted together and Pins 5, 6,

7 and 8 shorted together.

8.

Part No. :

6N135 / 6N136 Series (Preliminary Date Sheet)

Page :

9 of 10

BNS-OD-C131/A4