⑥

3.5.OUTPUT

3.5.1. Stand-by power

The system shall provide a standby output of 5V +/- 5% with a current sourcing capability of

3.0A. The ripple and noise of this output shall be less than 50mVp-p. The output shall be

active whenever AC power is applied to the unit. *PSON shall have no effect on this output.

3.5.2. Output current capacity

Each of the 1+1 redundant power supply module shall be capable of supplying the output

currents of as below subject to the listed conditions and a total output power of 700watts.

Due to the active current share, the actual maximum steady state current from each output

shall be about half of the maximum current specified.

OUTPUT CURRENT

REGULATION

OUTPUT

OUTPUT

VOLTAGE

TC-700RVN2

Min.

Max.

LOAD

LINE

RIPPLE & NOISE max. (P-P)

+5V

1A

32A

±5％

％

％

％

±1％

％

％

％

50mV

+3.3V

1A

25A

±5％

％

％

％

±1％

％

％

％

50mV

+12V

3A

52A

±5％

％

％

％

±1％

％

％

％

70mV

-12V

0A

1A

±5％

％

％

％

±1％

％

％

％

70mV

+5SB

0.1A

3A

±5％

％

％

％

±1％

％

％

％

50mV

REMARKS:

1.Total Max output of +5V AND +3.3V not exceed 200W

2.Power module Total output power not exceed 700W forTC-700RVN2

3.Noise bandwidth is from DC to 20MHz.

3.5.3. Output voltage rise time

The rise time shall be less than 20 ms measured from 10% to 90%.

3.5.4. Output voltage hold up time

Upon loss of an ac input at any input voltage between 115/230V, the output

voltages of the system shall remain in regulation for at least 16 ms at full output

loads.