SI5341 datasheet(10/56 Pages) SILABS

Teilenummer	SI5341

Bauteilbeschribung	LOW-JITTER, 10-OUTPUT, ANY-FREQUENCY, ANY-OUTPUT CLOCK GENERATOR

Download	56 Pages

Scroll/Zoom	100%

Hersteller	SILABS [Silicon Laboratories]

Direct Link	http://www.silabs.com

Logo

10 / 56 page

Si5341/40

10

Rev. 1.0

Common Mode Voltage1

Normal Mode or Low Power Modes

VCM

VDDO = 3.3 V

LVDS

1.10

1.25

1.35

V

LVPECL

1.90

2.05

2.15

VDDO = 2.5 V

LVPECL

LVDS

1.15

1.25

1.35

VDDO = 1.8 V

Sub-LVDS

0.87

0.93

1.0

Rise and Fall Times

(20% to 80%)

tR/tF

Normal Mode

—

170

240

ps

Low Power Mode

—

300

430

Differential Output Impedance2

ZO

Normal Mode

—

100

—



Low Power Mode

—

650

—



Power Supply Noise Rejection3

PSRR

Normal Mode

10 kHz sinusoidal noise

—

–93

—

dBc

100 kHz sinusoidal noise

—

–93

—

500 kHz sinusoidal noise

—

–84

—

1 MHz sinusoidal noise

—

–79

—

Low Power Mode

10 kHz sinusoidal noise

—

–98

—

dBc

100 kHz sinusoidal noise

—

–95

—

500 kHz sinusoidal noise

—

–84

—

1 MHz sinusoidal noise

—

–76

—

Table 5. Differential Clock Output Specifications (Continued)

(VDD = 1.8 V ±5%, VDDA =3.3 V ±5%, VDDO = 1.8 V ±5%, 2.5 V ±5%, or 3.3 V ±5%, TA = –40 to 85 °C)

Parameter

Symbol

Test Condition

Min

Typ

Max

Units

Notes:

1. The typical normal mode (or low power mode) LVDS maximum is 100 mV (or 80 mV) higher than the TIA/EIA-644

maximum. For normal and low-power modes, the amplitudes are programmable through register settings and can be

stored in NVM. Each output driver can be programmed independently. See Appendix A of the Si5341/40 Reference

Manual.

2. Driver output impedance depends on selected output mode (Normal, Low Power).

3. Measured for 156.25 MHz carrier frequency. Sinewave noise added to VDDO (1.8 V = 50 mVpp, 2.5 V/

3.3 V = 100 mVpp) and noise spur amplitude measured.

4. Measured across two adjacent outputs, both in LVDS mode, with the victim running at 155.52 MHz and the aggressor

at 156.25 MHz. Refer to application note, “AN862: Optimizing Si534x Jitter Performance in Next Generation Internet

Infrastructure Systems”, guidance on crosstalk minimization.

5. For other amplitudes see Appendix A of the Si5341/40 Reference Manual.

6. See Note 4, but in this case the measurement is across two output clocks that have a single clock between them.

7. Same as Note 4, but the Si5340 has less crosstalk due to the spacing of adjacent outputs.

OUTx

Vpp_se

Vpp_diff = 2*Vpp_se

Vcm

Ähnliche Beschreibung - SI5341

Hersteller	Teilenummer	Datenblatt	Bauteilbeschribung
Skyworks Solutions Inc.	SI5341	1Mb / 49P	Low-Jitter, 10 or 4-Output, Any-Frequency, Any-Output Clock Generator Rev. 1.1
Silicon Laboratories	SI5341	5Mb / 53P	Low-Jitter, 10 or 4-Output, Any-Frequency, Any-Output Clock Generator
Skyworks Solutions Inc.	SI5391	1Mb / 45P	Ultra Low-Jitter, 12-Output, Any-Frequency, Any-Output Clock Generator Rev. 0.7
Silicon Laboratories	SI5345	1Mb / 60P	10-Channel, Any-Frequency, Any-Output Jitter Attenuator/ Clock Multiplier
Silicon Laboratories	SI5345	1Mb / 62P	10-CHANNEL, ANY-FREQUENCY, ANY-OUTPUT JITTER ATTENUATOR/CLOCK MULTIPLIER
Skyworks Solutions Inc.	SI5345	976Kb / 58P	10-Channel, Any-Frequency, Any-Output Jitter Attenuator/ Clock Multiplier Rev. 1.2
	SI5357	1Mb / 27P	12-Output Any-Frequency Clock Generator Rev. 1.0
	SI5334	1Mb / 37P	PIN-CONTROLLED ANY-FREQUENCY, ANY-OUTPUT QUAD CLOCK GENERATOR Rev. 1.3
Silicon Laboratories	SI5338	1Mb / 46P	I2C-PROGRAMMABLE ANY-FREQUENCY, ANY-OUTPUT QUAD CLOCK GENERATOR
Silicon Laboratories	SI5338	715Kb / 170P	I2C-PROGRAMMABLE ANY-FREQUENCY, ANY-OUTPUT QUAD CLOCK GENERATOR

More results

SI5341 Datenblatt(PDF) 10 Page - Silicon Laboratories

SI5341 Datenblatt(HTML) 10 Page - Silicon Laboratories

Ähnliche Teilenummer - SI5341

Ähnliche Beschreibung - SI5341

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56

Datenblatt Download

Link URL