TSB41BA3I datasheet(5/68 Pages) TI1

Teilenummer	TSB41BA3I

Bauteilbeschribung	IEEE 1394b THREE-PORT CABLE TRANSCEIVER/ARBITER

Download	68 Pages

Scroll/Zoom	100%

Hersteller	TI1 [Texas Instruments]

Direct Link	http://www.ti.com

Logo

5 / 68 page

TSB41BA3B

IEEE 1394b THREE-PORT CABLE TRANSCEIVER/ARBITER

SLLS678 − SEPTEMBER 2005

5

POST OFFICE BOX 655303

• DALLAS, TEXAS 75265

description (continued)

The LPS input is considered inactive if it remains low for more than the LPS_RESET time (see the LPS terminal

definition) and is considered active otherwise. When the TSB41BA3B detects that the LPS input is inactive, the

PHY-LLC interface is placed into a low-power reset state in which the CTL and D outputs are held in the logic

0 state and the LREQ input is ignored; however, the PCLK output remains active. If the LPS input remains low

for more than the LPS_DISABLE time (see the LPS terminal definition), then the PHY-LLC interface is put into

a low-power disabled state in which the PCLK output is also held inactive. The TSB41BA3B continues the

necessary repeater functions required for normal network operation regardless of the state of the PHY-LLC

interface. When the interface is in the reset or disabled state and the LPS input is again observed active, the

PHY initializes the interface and returns to normal operation. The PHY-LLC interface is also held in the disabled

state during hardware reset. When the LPS terminal is returned to an active state after being sensed as having

entered the LPS_DISABLE time, the TSB41BA3B issues a bus reset. This broadcasts the node self-ID packet,

which contains the updated L bit state (the PHY LLC now being accessible).

The PHY uses the S5_LKON terminal to notify the LLC to power up and become active. When activated, the

output S5_LKON signal is a square wave. The PHY activates the S5_LKON output when the LLC is inactive

and a wake-up event occurs. The LLC is considered inactive when either the LPS input is inactive, as previously

described, or the LCtrl bit is cleared to 0. A wake-up event occurs when a link-on PHY packet addressed to this

node is received, or conditionally when a PHY interrupt occurs. The PHY deasserts the S5_LKON output when

the LLC becomes active (both LPS sensed as active and the LCtrl bit set to 1). The PHY also deasserts the

S5_LKON output when a bus reset occurs, unless a PHY interrupt condition exists which would otherwise cause

S5_LKON to be active. If the PHY is power-cycled and the power class is 0 through 4, then the PHY asserts

S5_LKON for approximately 167

μs or until both the LPS is active and the LCtrl bit is 1.

Ähnliche Beschreibung - TSB41BA3I

Hersteller	Teilenummer	Datenblatt	Bauteilbeschribung
Texas Instruments	TSB81BA3IPFPEP	711Kb / 57P	[Old version datasheet] IEEE 1394b THREE-PORT CABLE TRANSCEIVER/ARBITER
	TSB41BA3B	1Mb / 67P	[Old version datasheet] IEEE 1394b THREE-PORT CABLE TRANSCEIVER/ARBITER
	TSB81BA3	810Kb / 57P	[Old version datasheet] IEEE 1394b THREE-PORT CABLE TRANSCEIVER/ARBITER
	TSB41BA3A	222Kb / 11P	[Old version datasheet] IEEE 1394b THREE-PORT CABLE TRANSCEIVER/ARBITER
	TSB41BA3D	875Kb / 59P	[Old version datasheet] IEEE 1394b THREE-PORT CABLE TRANSCEIVER/ARBITER
	TSB41BA3D	754Kb / 60P	[Old version datasheet] IEEE 1394b THREE-PORT CABLE TRANSCEIVER/ARBITER
	TSB41BA3A-EP	768Kb / 69P	[Old version datasheet] IEEE 1394b THREE-PORT CABLE TRANSCEIVER/ARBITER
	TSB41BA3B-EP	1,023Kb / 67P	[Old version datasheet] IEEE 1394b THREE-PORT CABLE TRANSCEIVER/ARBITER
	TSB81BA3D	682Kb / 61P	[Old version datasheet] IEEE 1394b THREE-PORT CABLE TRANSCEIVER/ARBITER
	TSB81BA3E	887Kb / 57P	[Old version datasheet] IEEE 1394b THREE-PORT CABLE TRANSCEIVER/ARBITER
	TSB81BA3-EP	764Kb / 56P	[Old version datasheet] IEEE 1394B THREE-PORT CABLE TRANSCEIVER/ARBITER